simbus input / output device

The simbusCAN I / O series is the heart of the simbus solutions from simsystems GmbH. Based on CAN bus standards, these small, independent LRUs (Line Replaceable Units) offer functions that can be configured flexibly to control and monitor various peripheral devices via the CAN bus. SYS-CAN-I / O-LRU_STEP Numerous applications require precise positioning. With the help of this driver module, such requirements can be easily implemented with our flexible LRU concept. Highlights: • Dual stepper motor control for standard stepper motors (phase angle 90 °) • Position referencing by means of an infrared light barrier Motor driver: • 2 drivers for independent control of two stepper motors • Interface I2C, addresses1 11xxxx0, 11yyyy1 • Step modes Half-step mode 1/4, 1/8, 1/16 micro-step mode • Phase angle 90 ° • Max. Coil current 800mA • Max. Full step frequency 1 kHz • Input voltages + 5VDC, + 12VDC • Temperature, wire break, short circuit, overcurrent and undervoltage monitoring Interfaces: • Connections 2x 4pin Micro Match (voltage, I2C, IR) 2x 4pin solder connector (motors) • Dimensions (W x H x D, excluding motors) 40 x 40 x 14mm • Mounting holes 4x M3 • Operating / storage temperature: -10 ° - 85 ° C TYPICAL APPLICATIONS • Microstep drivers for watch instruments • General stepper motor control Prices currently only on request